Warning
T
o avoid damages to the Meter or to the devices under test, disconnect circuit
power and discharge all the high-voltage capacitors before measuring resistance.
To avoid harm to yourself, do not input higher than DC 60V or AC 30V voltages.
To measure resistance, connect the Meter as follows:
1. Insert the red test lead into the terminal and the black test lead into the COM
terminal.
2. Set the rotary switch to resistance measurement ( ) is default or press BLUE
button to select measurement mode.
3. Connect the test leads across with the object being measured. If there is lead on
the resistor or SMT resistor, it is more convenience to use the included multi-
purpose socket to carry out testing.The measured value shows on the display.
Model UT61A/61B/61C/61D/61E: OPERATING MANUAL
22
To Next Page
Loading...
Need help?
General
