UNI-T UTG9005C-II User Manual

2.3 Panel and Keys Introduction
2.3.1 Front Panel
This product provides a simple, intuitive, easy-to-use front panel, as shown
below:
1.EBTN display
12. System setting
11. Numeric keypad
10. Direction key
9. Frequency
meter and
modulation
8.Synchronization
/channel output
control
7. Parameter unit selection
6. Waveform selection5. Parameter menu
3. Modulation
input/count
input/
synchronization
output
4. Channel
output
Picture 2-1 Front panel
1. Display Screen
EBTN LCD
2 Power On/Off
Turn the instrument on or off.
3 Modulation Input/ Frequency Meter Input/ Synchronization Output
1) In AM, FM or frequency sweep, when the modulation source is selected
as external, the modulation signal is input through the external modulation
input terminal.
.
.
2) When the frequency meter function is enabled, the signal to be measured
is input through this interface.
3) When the modulation (or the modulation source is internal) and the
frequency meter is turned off, the device will output the synchronization
signal through this interface.
4. Channel Output
Signal source channel output terminal.
5. Parameter Menu
Set waveform parameters.
6. Waveform Selection
Waveform type quick selection key
7. Parameter Unit
Select the corresponding unit after entering the channel parameter value.
8. Synchronization/Channel Output Control
SYNC is the synchronization signal output button; Output is the signal
output button. Short press Output to turn on/off the signal source channel
output; long press Output to turn on the power module output channel,
short press to turn off the output.
Note: The channel output terminal is set with overvoltage protection,
which is performed when one of the following conditions is met:
Amplitude setting value > 625mVpp, input voltage > 12.5V ,︱︱
frequency < 10kHz.
Amplitude setting value 625mVpp, input voltage > 2.5V ,≤︱︱
frequency < 10kHz.
* When overvoltage protection occurs, the warning indicator on the upper
right corner of the screen flashes for 3 seconds and the buzzer beeps.
9 Frequency Meter and Modulation.
Count is the frequency meter button, Mode is the modulation button.
10 Direction Key.
Used to increase or decrease numbers, move cursors, switch waveforms,
and confirm, etc.
11 Numeric Keyboard.
Used to enter the required parameters, including numeric keys 0 to 9,
decimal point“.”, and symbolic keys “+/-”, “ ”.
12 System.
System setting button
UTG9000C-II User Manual

UNI-T UTG9005C-II Specifications

General

Brand	UNI-T
Model	UTG9005C-II
Category	Portable Generator
Language	English