1. UNPACKING AND INSTALLATION
Please make sure that the packaging is undamaged and the product
has not suffered from rough handling during transportation, otherwise we
highly recommend you contact your Authorised Dealer for advice before
proceeding with the set-up.
Carefully remove your CD player and all the accessories from the carton.
IMPORTANT! After unpacking please allow at least two hours
before operating the device in order for it to adapt to the room
temperature. This time is needed to prevent any possible damage
caused by the condensation which can form during transportation.
Please note, that condensation can form every time the amplifier is
moved from a cold to a warm place.
Keep all packing materials: every time you will need to transport the Unico
CDDue player, its original purpose-designed carton will provide the safest
packaging.
The CDDue should be positioned in a safe place on a plane surface.
Adequate clearance must be left above and around the device to guarantee
correct ventilation.
We also suggest you leave enough free space behind your CDDue to allow
the connecting cables sufficient room to bend without crimping or strain,
and we strongly recommend not placing the device directly onto a power
amplifier or, in general, close to a heat source.
2. CONNECTION TO THE MAINS
The Unico CDDue is set at the factory to the appropriate mains voltage of
the country it will be shipped to.
IMPORTANT! The voltage setting may not be changed by the user.
Never connect the CD player to AC mains if the local voltage doesn’t
match the value indicated on the rear panel!
The mains fuse is located in the fuse-holder integrated in the IEC mains
socket. The correct value of the mains fuse is indicated on the rear panel of
the Unico CDDue and in the technical specifications listed at the end of this
manual.
IMPORTANT
! Always replace fuses with new ones of the same type
and value.
To Next Page
Loading...
Need help?
General
