Unison Research Unico Secondo User Manual

Unison Research

Unico Secondo
13
(Note: It is advisable to switch off if the amplifier if the thermic
protection device intervenes. This will speed up return to normal
operation.)
LED1 on and LED2 blinking:
indicates that the amplifier is receiving a signal from the IR remote
control (volume changing)
In case of intervention by the thermal protection device, check that the
amplifier has adequate ventilation.
If there is a temporary loss of mains electricity (even of very short duration)
the amplifier will restart in automatic start-up mode.
7. INTERNAL FUSES
Inside the Unico Secondo there are six fuses.:
F
1
= 6,3AT / 250V
F
2
= 6,3AT / 250V
F
3
= 1,6AT / 250V
F
4
= 1,6AT / 250V
F
5
= 1AT / 250V
F
6
= 1AT / 250V
The value for the main fuses is:
10AT / 250V for 100V/120V/130V mains voltage
6,3AT / 250V for 220V/230V/240V mains voltage
These fuses are all 5 x 20mm glass fuses. If one of these fuses should blow
we advise you to consult your Authorised Dealer or Service Centre for
advice.
8. REMOTE CONTROL
Unison Research

amplifiers are supplied complete with infrared
remote control of volume.
Battery replacement
Your remote control handset is fitted with a battery type CR2032 -
3V (lithium battery) for wooden handset and AA-1,5V type for plastic one.

Unison Research Unico Secondo Specifications

General

Brand	Unison Research
Model	Unico Secondo
Category	Amplifier
Language	English