12
IMPORTANT: If you do not press a button within 20 seconds
the LED light will turn off. The remote will exit the program-
ming mode and you will have to start over.
Repeat Steps 1-2 for all other Components.
(Note: SimpleSound is what’s technically referred to as
a “Punch Through” feature and is not limited to volume
control. It can also be applied to other groups of buttons.
If you find yourself switching to a particular component
mode frequently to access a particular control, consider
using Punch Through. Follow the same procedure as above.
When you get to Step 2, pressing the first button listed in the
groups below will program all of the buttons in the group.
VOLUME: VOLUME UP, VOLUME DOWN AND MUTE
CHANNEL: CHANNEL UP, CHANNEL DOWN AND PREVIOUS
CHANNEL Number (0-9)
VCR/DVD: PLAY, STOP, PAUSE, REWIND, FAST FORWARD,
SKIP+, SKIP-, RECORD
DVD/SAT OSD: MENU, GUIDE, INFO, EXIT, UP, DOWN, LEFT,
RIGHT, SEL
Press the VOLUME UP button and then press either the TV
or AUDIO component button that you want to use for volume.
The Component LED light will blink three times to confirm that
it is saved. This sets up three buttons (Volume Up, Volume Down
and MUTE) as a group for that component.
To Next Page
Loading...
Need help?
General
