Preparation before Use
2-46
Loading Paper
Paper can be loaded standardly in the cassette and the multi purpose tray. A paper feeder is also available as an
option (refer to Overview of Optional Equipment on Appendix-2).
Before Loading Paper
When you open a new package of paper, fan the sheets to
separate them slightly prior to loading in the following steps.
1 Bend the whole set of sheets to swell them in the middle.
2 Hold the stack at both ends and stretch it while keeping
the entire stack swelled.
3 Raise the right and left hands alternately to create a gap
and feed air between the papers.
4 Finally, align the papers on a level, flat table.
If the paper is curled or folded, straighten it before
loading. Paper that is curled or folded may cause a jam.
CAUTION: If you copy onto used paper (paper already used
for copying), do not use paper that is stapled or clipped
together. This may damage the machine.
NOTE: If printouts are curled or not neatly stapled, turn the
stack in the cassette upside down.
Avoid exposing opened paper to high temperatures and
high humidity as dampness can be a cause of problems.
Seal any remaining paper after loading in the multi
purpose tray or cassettes back in the paper storage bag.
If the machine will not be used for a prolonged period,
protect all paper from humidity by removing it from the
cassettes and sealing it in the paper storage bag.
NOTE: If you use special paper such as letterhead, paper
with holes or paper with pre-prints like logo or company
name, refer to Paper on Appendix-9.
To Next Page
Loading...
Need help?
General
Weight and Dimensions
