OPERATING INSTRUCTIONS
CARE AND MAINTENANCE
TROUBLESHOOTING
1. ADJUSTING AIR SPEED
Adjust the desired speed by rotating the switch knob
0 Stop 1 Low 2 Medium 3 High
Orbital Oscillation Off
Oscillation orbtale hors
Orbital Oscillation
Oscillation orbtale
2. ADJUSTING INTERNAL ORBITAL OSCILLATION FEATURE
The internal orbital oscillation feature can be turned on by rotating
the switch knob to the side sticked "Orbital Oscillation". To disengage
the oscillation feature, turn the switch knob to the side sticked
"Orbital Oscillation Off".
Unplug the appliance before cleaning. Don't use any water for cleaning metal surfaces. In order to
remove the dust from the protective screen, use a vacuum cleaner or remove the front protective
screen by removing the securing screw on the edge of the screen with a screwdriver. After cleaning,
remount the safety screen. After doing this, fasten the securing screw on the edge of the protective
screen.
The fan fails to
operate.
1. Fan may not be plugged in.
2. There may some be obstructions
in the fan.
3. Orbital oscillating feature is not
turned on.
1. Make sure the fan is plugged in
and electrical outlet is working
properly.
2. Check for any obstruction. If you find
an obstruction, turn the fan to “0”.
Unplug the fan and carefully remove
the obstruction. Plug the fan in and
turn it on again, referring to the
OPERATING INSTRUCTIONS.
3. Make sure that orbital oscillation
switch is turned on.
Orbital oscillation
feature not
working.
PROBLE
To Next Page
Loading...
Need help?
General