Val Controls I 24-AF Series User Manual

DID-UM-002
Val Controls A/S • Limfjordsvej 3 • DK-6715 Esbjerg N • Tel. +45 7547 0600
vc@valcontrols.com • www.valcontrols.com
Revision: 10
9/74
4.3.4 Setup menu
Setup Menu
Description
1
Calibration
1
Auto calibration
Start the auto calibration
2
End point cal.
Start endpoint calibration
3
Start PST ref
Start the partial stroke reference
4
Start FST ref
Start the full stroke reference
5
Start SOT ref
Start the solenoid valve test reference
2
Identification
Software ID, Software version, serial no. and tag no.
3
Live
Current state of digital and analogue signals
4
Event log
The last 10 events
5
Scheduler
Configure the scheduler
6
HART
Configure HART communication
7
Modbus
Configure Modbus configuration
8
Display
Adjust the contrast and backlight
4.4 Bluetooth
Bluetooth can be used to control the valve system though the IDC or to download signatures to a
mobile device.
Range:
IDC24-AF with external antenna: 20 meters
IDC24-F with external antenna: 20 meters
IDC24-A with internal antenna: 2 meters
IDC24-AF with internal antenna and glass lid: 2 meters
When connecting to a IDC with internal antenna, the connecting devices must be right in front of
the IDC.
After the Tag no. is changed the device must be power cycled to update the Bluetooth name.
4.5 Internal memory
The device is available in two models, standard or with local storage on microSD card.
A signature contains all test data and a curve of the test.
4.5.1 Standard
The last 10 events are stored in memory.
The IDC will store test data from the last performed test of each type
• one PST
• one PST reference
• one FST
• one FST reference
• one SOT
• one SOT reference

Val Controls I 24-AF Series Specifications

General

Brand	Val Controls
Model	I 24-AF Series
Category	Controller
Language	English