EasyManuals Logo
Home>Valtra>Tractor>T CVT

Valtra T CVT User Manual

Valtra T CVT
31 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #30 background imageLoading...
Page #30 background image
Starting assistance
WARNING:
Never use any starter fluid or aerosol
sprays.
This could cause an explosion and very serious
injuries.
GUID-3C9BC39A-A890-4043-8775-CDAD4D2107E9-high.jpg [High]
Fig. 8
2.7.3 Starting the tractor with jump start cables
IMPORTANT:
Do not attempt to boost a damaged battery.
Do not touch the connectors on the jump start cables.
Do not allow your body to touch the vehicle (chassis frame) when making the connections.
Do not use a damaged battery or a damaged booster.
Only use a battery or a booster with a similar voltage.
To avoid accidental hazards when working near the battery, remove all jewellery or metal accessories,
such as rings or bracelets.
Do not disconnect the damaged battery — this can damage the vehicle's electrical system.
Procedure
1. The ignition key must be in the OFF position.
ATTENTION:
The tractor engine must not start up or move accidentally.
2. Connect the clamp of the red cable to the positive terminal (+) of the flat battery.
3. Connect the other clamp of the red cable to the positive terminal (+) of the battery in good condition
or to the positive terminal (+) of a recovery vehicle.
4. Connect the clamp of the black cable to the negative terminal (-) of the battery in good condition.
5. Finally, connect the other black clamp to any part of the engine block or chassis frame (metal part).
ATTENTION:
To avoid the risk of a spark and potential explosion due to hydrogen from the battery, never make
this final connection to the negative terminal (-) of the damaged battery.
6. Leave the flat battery to recharge for a few minutes, or even longer if possible, before attempting to
start.
7. Start the engine of the vehicle. Once started, leave the engine running for a few minutes.
8. Without turning off the engine you have helped to start, disconnect the jump start cables from the
battery or the booster in reverse order.
ATTENTION: At the end of the operation, make sure that the red and black cables do not touch each
other when they are still connected to a battery.
IMPORTANT: Corroded battery terminals may interfere with, or even prevent the tractor from
starting.
GUID-E2027280-7FFF-4D23-BC48-6F082B47738D [V1]
2. Safety instructions and safety points
T CVT 37
ACW2071910

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Valtra T CVT and is the answer not in the manual?

Valtra T CVT Specifications

General IconGeneral
BrandValtra
ModelT CVT
CategoryTractor
LanguageEnglish

Related product manuals