9
support.vax.co.uk
GETTING STARTED
IMPORTANT: Your dirty water tank is fitted with a float. When the dirty water tank is full, or the
floorhead is not in contact with the floor, the float will shut off the suction on the machine. You will
be able to hear if this has happened as the motor noise on the machine will increase. Once the float
is activated, check if the dirty water tank is full and empty if necessary. If the dirty water tank is not
full, continue to check for blockages.
OPERATION
Place your foot on the base and pull the
handle backwards to recline.
Press the on/off button to switch the
machine on. The machine will always
start in High Mode.
For an improved runtime, press the
mode selector button to switch to
Eco Mode.
For a more intense clean, press the
mode selector button to switch to
High Mode.
Press the trigger on the handle to
release water and solution. Release the
trigger to recover the water and solution.
For best results apply water/solution
on the forward stroke and release the
trigger on the backward stroke to pick up
water/solution. For a dryer finish, follow
with an additional dry stoke without the
trigger pressed.
During use, regularly empty the dirty
water tank ensuring the water does not
exceed the max fill line marked on the
side of the tank.
To Next Page
Loading...
Need help?
General
