Vax PowerWash 2000W User Manual

Attach both wheels
and push until they
click into place.
Attach the hose connector
to water inlet by turning
clockwise until tight.
Slot the handle in to the
top of the machine and
insert the 2 screws, turn
clockwise to tighten.
Align the pressure hose and
cord storage hook onto the
back of the machine and
secure with 2 screws.
Assembling your pressure washer
Preparing your pressure washer for use
Always make sure the pressure washer and water supply is o before connecting or disconnecting the hose
and accessories.
Pushthepressurehosermly
to the water outlet and turn the
pressure hose collar clockwise
until tight.
Whilstrmlypushingthelance
into the trigger handle turn
clockwise to lock into position.
LOCKED
UNLOCKED
A trigger safety lock is located
underneath the handle. The safety
lock should always be in LOCKED
position before connecting/
disconnecting the pressure hose to
the trigger handle.
To remove the lance from the trigger handle
rmlypushandtwistthelanceanti-clockwise.
When unlocked pull to remove.
Getting started Using your machine
PLEASE READ ‘LET’S TALK SAFETY’ AT THE BEGINNING BEFORE USE
Make sure water supply
is not connected. Firmly
push the water hose pipe
with suitable connector
onto the water inlet to
lock into position.
Connect water hose pipe to
a suitable water supply and
turn water on.
Before plugging the machine
in, press the unlock safety
button on the trigger handle
and squeeze the trigger until
water starts to ow through
the nozzle.
IMPORTANT: Always use an RCD (Residual Current Device) adaptor when using this pressure washer.
WARNING: Don’t leave the pressure washer running when not in use, or more than 5 minutes to prevent overheating.
Before switching the machine on, the trigger handle must be squeezed to release water and to remove any airlocks in the
machine or pressure hose. Always release any build up pressure in the handle prior to disconnecting the hose.
Connect the power cord
to the mains supply via
an RCD adaptor.
IMPORTANT: Always make sure the trigger safety lock is in the LOCKED position when not in use or connecting
/disconnecting the pressure hose.
Always check water hose, pressure hose, lance and accessories are not damaged broken or worn before use.
To connect pressure hose to trigger
handle, press the pressure hose
release button and push pressure
hose to lock into position. Gently
pull the pressure hose to check the
connection.
Push the ‘I’ switch to turn on.
The machine will run for a
few seconds then stop but no
water will be released.
Squeeze the trigger on the trigger
handle to release a high pressured
water jet, and start cleaning.
Don’t aim the pressure washer
directly at people, animals, plants,
electrical components, wires or the
pressure washer itself.
WARNING
Push ‘O’ switch to turn o.
After connecting
pressure hose, lance
and accessories check
theyaresecurelytted
and lock in place before
turning on.

Vax PowerWash 2000W Specifications

General

Brand	Vax
Model	PowerWash 2000W
Category	Pressure Washer
Language	English