15
MAINTENANCE & CLEANING
Removing and cleaning the nozzle
Pull to release the nozzle
and unhook the nozzle
tabs from underneath the
machine to remove
Rinse the nozzle under
warm water (max 40�C)
to remove dirt/debris.
Remove both tanks and tilt
the machine back.
To replace the nozzle,
hook the tabs on the base
of the nozzle under the
tabs on the base of the
machine. Lower the nozzle
backwards and push until
it clicks into place.
Insert the cleaning tool
into the nozzle. Slide to
the edges and corners to
remove any stubborn dirt
and debris.
IMPORTANT: Carpets should be dry vacuumed thoroughly before washing. This will prevent excessive build up of
dirt/debris in the nozzle. If the nozzle is fitted incorrectly, this will cause poor dirty water pick up.
40°C
MAX
To Next Page
Loading...
Need help?
General
