11
maintenance / troubleshooting
Separate the foam filter from the float (Fig.6/2).
Rinse the filter in water (40°C max) (Fig.6/3).
Allow the filter to air dry completely before storing your
machine (Fig.6/4).
6. Troubleshooting
WARNING: To reduce the risk of personal injury,
unplug the vacuum cleaner before performing
maintenance or troubleshooting checks.
PROBLEM: The cleaner won't run.
Cause: Not properly plugged into electrical outlet.
Solution: Plug in firmly.
Cause: No electricity in electrical outlet.
Solution: Check fuse or breaker.
Cause: On/off switch not turned on.
Solution: Push on/off switch to ‘on’.
Cause: Blown fuse/tripped breaker.
Solution: Reset circuit breaker or replace fuse.
PROBLEM: Cleaner won’t pick up/loss of suction.
Cause: Dirty water tank is full.
Solution: Switch off and unplug cleaner. Empty dirty
water tank as shown in Section 4.
Cause: Dirty water tank not installed correctly.
Solution: Refer to page 9 for fitting information.
Cause: Obstruction in hose/wash tool
Solution: Remove hose and clear obstruction.
Cause: Broken or worn belt.
Solution: Replace the belt. See page 10.
Cause: Brushbar is worn.
Solution: Replace the brushbar. See page 10.
PROBLEM: Dust escaping from the vacuum.
Cause: Dirty water tank is full.
Solution: Switch off and unplug cleaner. Empty dirty
water tank as shown in Section 4.
Cause: Dirty water tank not installed correctly.
Solution: Refer to page 9 for fitting information.
Cause: Solution tank not installed correctly.
Solution: Make sure the tank is securely locked in place
PROBLEM: Clean water/solution won’t dispense.
Cause: Clean water tank not installed correctly.
Solution: Make sure the tank is securely locked in place.
Cause: Clean water tank tank empty.
Solution: Refill tank. Refer to page 6 for instructions.
To Next Page
Loading...
Need help?
General
