Getting started
Assembling your vacuum cleaner
Lift handle up and
click into place.
Put dusting brush into dusting
brush holder with brushes
facing outwards.
Line up latch on accessory hose,
push until clicks into place.
Line up TurboTool brushes into
TurboTool holder, push into place
until it clicks (some models only).
Push accessory hose into
hose to machine connector.
Push extension tube and
crevice tool onto holder.
Before you begin cleaning
CAUTION: Always switch o the vacuum cleaner before connecting or disconnecting the hose/attachments
or removing and emptying the dirt container.
IMPORTANT: The vacuum cleaner is equipped with a thermal cut-out. If for any reason the vacuum cleaner does
overheat the thermostat will automatically turn the vacuum cleaner o. If this happens switch the vacuum cleaner o
and unplug from electrical socket. Remove and empty the dirt container also check the vacuum cleaner for blockages.
Allow the vacuum cleaner to cool for approximately 1 hour (if you have cleaned the lters please wait 24 hours for the
lters to fully dry before putting back into the machine).
Filters require cleaning at least every 3-6 months. If the vacuum cleaner is blocked, switch o and unplug before
removing the blockage.
When the vacuum cleaner is stood in the upright position, or when using the hose and tools the brushbar height adjuster
must be set to the highest setting.
PLEASE READ ‘LET’S TALK SAFETY’ AT THE BEGINNING BEFORE USE
To Next Page
Loading...
Need help?
General
