vax.co.uk
4
assembly
3. Assembly
IMPORTANT: Never unscrew the tank cap during
use. The tank is under pressure.
IMPORTANT: Do not operate a damaged appliance
or damaged accessories.
IMPORTANT: This steam cleaner is not intended
for commercial use.
NOTE: Carpets should be dry vacuumed thoroughly
before using the steam cleaner.
NOTE: If the supply cord is damaged, it must be replaced
by the manufacturer, a Vax service agent or similarly
qualified persons in order to avoid hazard
The hose with steam gun must be connected to the
appliance and the desired accessory must be attached
before the steam cleaner can be used. The steam cleaner
has an accessories compartment that houses the detail
nozzle, both brush nozzles, the jet nozzle and the 2-in-1
nozzle. Open the accessories compartment by pulling the
locking handle upwards and lifting the transparent cover
of the accessories compartment off towards the front
(Figs.3/1 and 3/2).
the cover. Slide the nose of the cover into the recess
above the steam socket and press it down firmly at the
back until the cover clicks into place.
First of all connect the hose to the steam socket on the
front of the steam cleaner. To do this, flip the black cover
flap down and push the connector of the hose firmly into
the steam socket until it clicks into place (Fig.3/3).
To remove the hose, press in both release buttons on the
right-hand and left-hand sides of the steam connector
and pull it out of the steam socket (Fig.3/4).
Extension Tubes
Assemble the extension tubes if the steam cleaner is to
be used to clean floors or difficult to reach areas. To do
this, push the open end of a tube onto the steam gun.
Push it onto the steam gun until the release button of
the steam gun clicks into place (Fig.3/5). Add one, two or
all three extension tubes as required.
Fig.3/1
Fig.3/4
Fig.3/2
Fig.3/3
To Next Page
Loading...
Need help?
General
