Vector JUMP-START SYSTEM User Manual

3
CAUTION:
Caution statements advise against certain conditions and practices that may
result in damage to vehicles, appliances and/or the jump-starter.
IMPORTANT:
Although this unit is delivered in a partially charged state, you must fully charge it
with the supplied 110/120 Volt AC charger for a full 24 hours before using it for
the first time. You cannot overcharge the unit using the AC charger method.
1) Use only the supplied cords/adapters for recharging this unit. Do not recharge
for more than 3-4 hours maximum using 12 Volt DC method. Recharge unit
after each use.
2) All On/Off switches should be in the OFF position when the unit is charging or
not in use. Make sure all switches are in the OFF position before connection to
a power source or load.
3) Never insert anything other than the supplied power/recharging cords or
recommended appliance power/recharging cords into the 12 Volt DC charging/
power socket on this unit. Do not use any accessory that is not recommended
or provided by the manufacturer.
4) Do not use this unit to operate appliances that draw more than 20 amps.
5) This system is designed to be used only on vehicles with 12 Volt DC battery
systems. Do not connect to a 6 Volt or 24 Volt battery system.
6) This system is not designed to be used as a replacement for a vehicular battery.
Do not attempt to operate a vehicle that does not have a battery installed.
7) Vehicles that have on-board computerized systems may be damaged if vehicle
battery is jump-started. Before jump-starting, read the vehicle’s owners manual
to confirm that external-starting assistance is advised.
8) Excessive engine cranking can damage a vehicle’s starter motor. If the engine
fails to start after the recommended number of attempts, discontinue jump-start
procedures and look for other problems that may need to be corrected.
9) Although this unit contains a non-spillable battery, it is recommended that unit be
kept upright during storage, use and recharging. To avoid possible damage that
may shorten the unit’s working life, protect it from direct sunlight, direct heat
and/or moisture.
10) Check unit periodically for wear and tear. Replace worn or defective parts imme-
diately. Contact Vector Customer Service department toll-free 866-584-5504.
11) Do not attempt to jump-start a frozen battery.
12) Never submerge this unit in water.

Vector JUMP-START SYSTEM Specifications

Power

peak ampere	1200 Amps
boost ampere	450 Amps
instantaneous cranking amps	450 Amps

Battery

battery type	12Volt, 19AH/20HR Sealed, Rechargeable Non-Spillable, Maintenance-free
dc charging adapter	12 Volt DC
ac charging adapter	110/120 Volt AC (700mA, 12 Volt DC Output)

Cables and Clamps

jumper cables	Heavy Duty, Welding Cable
cables clamps	450 Amp, Heavy Duty Clamps
reverse polarity detection	2.5 Volts (min)

Weight and Dimensions

height	12.75 in (32.39 cm)
width	11 in (27.94 cm)
depth	5.5 in (13.97 cm)
weight	16 lbs (7.26 Kg)