14
14
9. FUSE REPLACEMENT
If external fuses blow, (or breakers trip), then there is a short or overload
in the DC wiring. Find and fix the problem before replacing the fuses (or
resetting the breaker). After fuse replacement, reconnect the inverter.
This power inverter is equipped with multiple internal fuses. Normally,
these fuses will not blow unless there is a serious problem inside the unit.
Internal fuses are replaceable, however, only electronically knowledgeable
people should attempt fuse replacement. If the unit is damaged during fuse
replacement, the warranty may be voided. Vector recommends contacting
Vector Technical Support for guidance. Based on experience, it is best to
return the unit to Vector for repair. Vector Technical Support can be
reached by calling toll free 866-584-5504. You may also contact us by
visiting our website@www.vectormfg.com.
10. SPECIFICATIONS
Output Connection ..........Dual North American Standard Receptacles
Output Voltage..................................Approx 110 volt AC RMS 60 Hz
Output Current....................................................................3.6 amps
Output Waveform ..................................Modified Sine Wave (filtered)
Input Voltage Range ..........................................10.5 to 15.5 volt DC
Low Voltage Alarm ........................................................10.6 volt DC
Low Voltage Shutdown....................................................10.0 volt DC
No Load Input Current ........................................................0.4 amps
Input Fuses ............................................................................Internal
Input Cables: ..........................One 12 volt DC Plug (up to 175 Watts)
Battery Clip Cable....................................................(up to 400 watts)
Additional Protection ..........................Overload, Over volt, Over temp
Weight....................................................................1.45 Lbs (.66 kg)
Length ..................................................................6.0 in. (15.24 cm)
Width ..................................................................6.0 in. (15.24 cm)
Height ..................................................................2.0 in. (5.08 cm)
11. WARRANTY
2 YEAR LIMITED WARRANTY PROGRAM
This limited warranty program is the only one that applies to this product, and it sets
forth all the responsibilities of Vector Manufacturing, Ltd., regarding this product. There
are no other warranties, other than those described herein.
This Vector Manufacturing, Ltd. product is warranted, to the original
To Next Page
Loading...
Need help?
General