4.3 CONNECTION TO LOAD
The MAXX 750 SST is equipped with dual standard North American AC power
receptacles. Plug the cord from the equipment you wish to operate into the
AC receptacle(s). The green LED indicator lights to indicate that the inverter is
functioning. Make sure the combined load requirement of your equipment does
not exceed 750 watts.
The MAXX 750 SST is engineered to be connected directly to standard electrical
and electronic equipment in the manner described above. Do not connect the
power inverter to household or RV AC distribution wiring. Do not connect the
power inverter to any AC load circuit in which the neutral conductor is connected
to ground (earth) or to the negative of the DC (battery) source.
WARNING: Do not connect to AC distribution wiring!
CAUTION: RECHARGEABLE APPLIANCES-Certain rechargeable devices are designed
to be recharged only by plugging them directly into an AC receptacle.
These devices may damage the inverter. Do not use the inverter to
recharge items that can only be plugged directly into an AC receptacle.
This problem does not occur with the majority of battery-operated equipment.
Most of these devices use a separate charger or transformer that is plugged into
an AC receptacle. The MAXX 750 SST is easily capable of running most charg-
ers and transformers.
4.4 PLACEMENT OF THE INVERTER
For best operating results, the inverter should be placed on a flat and/or solid
surface. A power cord measuring 3 feet (1.0 meter) has been provided for easy
positioning of the inverter. The inverter should only be used in locations that meet
the following criteria:
DRY - Do not allow water and/or other liquids to come into contact with the
MAXX 750 SST inverter.
COOL - Ambient air temperature should be between 30°F (-1°C) non-condensing,
and 105°F (40°C). Do not place the inverter on or near a heating vent or any
piece of equipment which is generating heat above room temperature. Keep the
inverter away from direct sunlight, if at all possible.
VENTILATED - Keep the area surrounding the inverter clear to ensure free air
circulation around the unit. Do not place items on or over the inverter during
operation. A fan is helpful if the inverter is operating at maximum power outputs
for extended periods of time. The unit will shut down if the internal temperature
exceeds operating temperatures. The unit will restart after it cools.
SAFE - Do not use the inverter near flammable materials or in any
locations that may accumulate flammable fumes or gases.
8
To Next Page
Loading...
Need help?
General