Vector VEC1093 A User Manual

6
INDICATORS
THE LARGE 3-CHARACTER DIGITAL DISPLAY character Digital Display in the upper left hand corner of the panel
indicates many conditions and/or status codes.
1) When AC power is applied to the charger, 2) actual charge rate in ampere, 3) when the battery is fully charged,
4) detected faults, operating modes and 5) when the charger is ready for the next mode selection. Displayed
information is called “status codes”. They are described below (FIGURE 5) and on the back of charger.
FIGURE 5
Below the Digital Display are series of four LEDS that light on the following conditions:
FAULT - Lights when any of several faults are detected - see F01 through F05 Codes as described above (If the Fault LED
lights, refer to TROUBLESHOOTING for details)
REV POLARITY - Lights when clamps are incorrectly connected to battery terminals.
CHARGING COMPLETE - Indicates Battery is charged. Charging Complete LED lights at same time the digital display shows
”FUL”.
ALTERNATOR GOOD - Lights when load or not load checks show the alternator is keeping up with the electrical load.
VEC1093 A
REV101103

Vector VEC1093 A Specifications

General

Brand	Vector
Model	VEC1093 A
Category	Battery Charger
Language	English