7
• Fuse or circuit breaker in accessory outlet is open. Reset breaker or check fuse,
and replace fuse if necessary.
• Ignition is switched off — start engine or switch ignition to “accessory” position.
• Fuse in unit’s power plug is blown — see Fuse Replacement section for location
of fuse and instructions for checking and replacing fuse.
• Cooler/warmer is not cooling or heating properly (fan is not turning).
Fan is defective. Call Customer Service department (866) 584-5504 for return/
replacement instructions. This unit is not user-serviceable, it must be returned to
manufacturer for professional service or repair. Any attempt to service by user will
void warranty.
• Cooler/warmer is not cooling or heating, but fan is turning.
Cooling unit is defective. Call Customer Service department (866) 584-5504 for
return/replacement instructions. This unit is not user-serviceable, it must be
returned to manufacturer for professional service or repair. Any attempt to service
by user will void warranty.
•Travel Cooler/Warmer takes longer than 2 hours to reach desired temperature
inside
– Low battery or supply voltage.
– Unit will attain desired temperature more efficiently if items are pre-heated
or pre-chilled.
– Fan area is blocked — move unit or object.
SPECIFICA
TIONS
Capacity: 14 can / 9 liter/ 2.38 gallons (US)
Operating Voltage: 12 volt DC
Low Voltage Cut-Off: Automatically shuts off (down) when vehicle battery
voltage drops below 10.7 volts DC
Power Cord: 7', with fuse protected (5 amp) plug
Amperage Draw: Approx. 4 amps (48 Watts)
Cooling Performance: Cools to average 40ºF (22ºC) below ambient
temperature
Warming Performance: Warms to average 120°F (48.8ºC)
Cold/Heat Transfer: Temperature efficient, aluminum-coated liner
Insulation: CFC-free polyurethane liner
Heat Dissipation: Built-in fan (long-life, brushless motor)
Warm/Cool System: Non-wearing thermo-electric
Dimensions: 9.76"W x 18.9"D x 12.5"H
Weight: 7.9 lbs.
6
CONNECTING TO AN AC/DC CONVERTER (SOLD SEPARATELY)
• Plug converter’s (VEC004A-120V) power cord into standard
120 volt 60 HZ outlet
• Make sure the unit’s HOT/OFF/COLD switch is in the OFF
position
• Insert the 12 volt DC plug on the power cord into the 12 Volt
DC Socket on the portable power supply.
• Continue with steps 3-9 for cooler or warmer function
OBSERVE ALL CAUTIONS AND WARNINGS.
Note: When used with a rechargeable power supply, a full-charge on the power
source is recommended for optimum performance.
FUSE REPLACEMENT
The power cord is fuse-protected against short-circuiting, by a 5-amp fuse located
in the tip of the 12 volt DC plug. If the DC socket is powered, but the unit does not
operate, then the cooler/warmer fuse may be open.
To inspect or replace the DC Power Cord Fuse:
1. Unscrew the end-cap of the power cord plug.
2. Remove fuse, inspect it for an open element, and replace with a new 5-amp
fuse, if needed.
3. Re-attach the end-cap to the plug.
4. If new fuse opens, call Customer Service department at (866) 584-5504 for
further instructions and possible return/replacement. This unit is not user-
serviceable, it must be returned to manufacturer for professional service or
repair. Any attempt to service by user will void warranty.
CARE AND MAINTENANCE
The Vector Thermo-Electric Travel Cooler & Warmer is ruggedly
constructed to provide years of dependable service.
• After each use, clean the unit, inside and out, with a soft cloth and mild soap
solution.
• Do not scrape, scratch or puncture the surface of the cooler with sharp objects or
abrasives.
•Dry the unit properly and store in a cool, dry place.
• Always make sure the power cord is disconnected before storing.
• Never allow the cooler/warmer to be immersed in liquid.
TROUBLESHOOTING
Problem/Possible Cause/Remedy
• Travel Cooler/Warmer is not functioning as cooler or warmer (fan is not
turning).
Accessory outlet of DC power supply is not functioning — check by plugging
in a 12 volt DC appliance. If not, clean accessory outlet and re-connect the
Vector Thermo-Electric Travel Cooler & Warmer.
VEC004A
(Sold Separately)
To Previous Page
Loading...
Need help?
Power
Performance
Weight and Dimensions
