Art.6276 3.5" colour display videophone
27 mm 144 mm
182 mm
Fig. 1
+VD
+20
V1
V/V2
GNDV
L
–
LB
AL
DOL
EXTC
SW
SW
DSW1 DSW2
PT1
PT2
VR1
PT3
SW2
A
I
B
D
G
E
H
F
C
Fig. 2
ART.6276 VX2200 6200 SERIES VIDEOPHONE FOR SYSTEMS
USING COMPOSITE VIDEO SIGNAL COAX OR BALANCED
TWISTED PAIR
DESCRIPTION
Surface mount videophone incorporating a 3.5” Hi-Res full col-
our active matrix LCD monitor, with “camera recall”, “door open/
concierge call”, “service” and “privacy” button.
2 LED’s one for generic use (door opening usually) and one to
indicate privacy service enabled.
Programmable settings: privacy duration, video mode (coax or
balanced), melody and number of rings.
Adjustments: call tone volume (3 levels), microphone volume,
picture hue, contrast and brightness.
LEGEND
A
Connection terminals
B
8 Way dip switch bank to set videophone address
C
4 Way dip switch bank to set video mode
D
Contrast adjustment trimmer
E
Hue adjustment trimmer
F
Microphone volume adjustment trimmer
G
Brightness control sliding wheel
H
Call tone volume switch
I
RJ-45 connector
PUSH BUTTONS
Service button
When pressed, shorts terminal SW to SW (Max 24 Vdc 50mA).
Privacy service
Press to enable the privacy service. The LED turns on. The service is deactivated by pressing again the same but-
ton or when the programmed time expires.
Door Open Push Button
• During a conversation, operation of this button will release the door from where the call originated. This will be
conrmed by an acoustic tone. If terminal DOL is connected, the “door open” LED under the symbol will also
illuminate.
• When the system is in stand-by, picking up the handset and pressing the buttons will book a call to the concierge
(If available).
Camera recall
When the system is in standby (no calls on the system), pick up the handset then press this button to open the
SPEECH/VIDEO to the door station. Press as many time as the ID value of the door panel to connect to.
ENG
To Next Page
Need help?
General
