66251230-EN - V1.4 - 15/06/16
1
6300 Series
Art.6378 - Installation instructions
Art.6378 3.5" hands free colour display videophone
27 mm 102 mm
182 mm
Fig. 1
PT3
PT2
6 7 8
1
2
3
5
4
ON
DSW2
1
2
3
4
ON
SW1
PT1 VR1
DSW1
+VD
+20
V1
V/2V
GNDV
L
–
LB
AL
DOL
EXTC
SW
SW
12Vo
12Vi
–
VM
A
E
D
C
B
FG
H
Fig. 2
ART.6378 VX2200 6300 SERIES HANDS FREE VIDEOPHONE
FOR SYSTEMS USING COMPOSITE VIDEO SIGNAL COAX OR
BALANCED TWISTED PAIR
Surface mount hands free intelligent videophone incorporating
a 3.5” Hi-Res full colour active matrix LCD monitor, with “answer/
camera recall”, “door open/concierge call”, “privacy” and one
“service” button plus 2 LED’s one for generic use (door opening
usually) and one to indicate privacy service enabled. Program-
mable settings: video mode (coax or balanced), privacy dura-
tion, melody and number of rings.
Adjustments: call tone volume (3 levels), speech volume, pic-
ture hue, contrast and brightness.
LEGEND
A
Connection terminals
B
8 Way dip switch bank to set videophone address
C
4 Way dip switch bank to set video mode
D
Contrast adjustment trimmer
E
Hue adjustment trimmer
F
Speech volume control
G
Brightness control
H
Call tone volume switch
PUSH BUTTON OPERATION DURING STANDBY FIG. 1
Service button
When pressed, shorts terminal “SW “ to “SW “ (max 24Vdc 50mA).
Privacy service
Press to enable the privacy service. The LED “ “ turns on. The service is deactivated by pressing again the same button or
when the programmed time expires.
Call the concierge
Press to book a call to the digital concierge if installed on the system.
Camera recall
Press a number of times equal to the ID value of the door panel to switch ON. The LED “ “ turns on.
When the connection is made, press again to end the call.
To Next Page
Need help?
General
