Viotek GN32DB User Manual

7
Section 4: Stand Installation
Keep the foam over the monitor before attaching the stand.
1. Open the package, take out the product with foam still attached, and gently place it on a
desktop or table.
2. Remove the extra parts and the foam covering the back of the monitor. Then press the
button to remove the stand plate.
Button
Stand Plate
3. Use the included screwdriver and two NO.1 screws to fasten the the base to the stem.Next,
use two NO.1 screws to fasten the stand plate to the stem.
NO.1 Screws
10mm x 2
NO.1 Screws
10mm x 2
4. Insert the stand’s plate into the opening on the back of the monitor. It should click into
place. Make sure the stand is securely attached to the back of the monitor then remove the
monitor from the remaining foam section and stand it up on a table or desk as desired.
If needed, the stand can easily be detached from the monitor by pressing the button near
the stand plate. Make sure the monitor is laid on a at surface before removing the stem.
Monitor
Stem
Stand Plate
Button

Viotek GN32DB Specifications

General

Brand	Viotek
Model	GN32DB
Category	Monitor
Language	English