Fuel Pre-filter, Change
1
Undo the cable from the water trap sensor.
2 Remove the water trap filter from the filter bracket.
Collect any spilled fuel in a collection vessel.
3 Remove the lower part of the water trap from the
filter.
4 Clean the lower part of the water trap with a soft rag.
Check that the drain hole in the lower part is not
blocked.
5 Install a new seal on the lower part and lubricate the
seal with diesel fuel. Re-install the lower part of the
filter.
6 Lubricate the seal with diesel fuel. Screw the filter
onto the filter bracket by hand until the rubber seal
just touches the mating surface. Then tighten a
further half turn, no more.
7 Connect the cable to the water trap sensor.
8 Where necessary, purge the fuel system; refer to
Bleeding the Fuel System.
Maintenance
87
47711089 09-2018 © AB VOLVO PENTA
To Next Page
Loading...
Need help?
General
