06 Locks and alarm
06
166
* Option/accessory, for more information, see Introduction.
Keyless drive* - unlocking
Unlocking takes place when a hand grasps a
door handle or the tailgate's rubberised pres-
sure plate is actuated - open the door or tail-
gate as normal.
Related information
•
Keyless drive* (p. 163)
•
Keyless drive* - locking (p. 165)
Keyless drive* - unlocking with the
key blade
If central locking cannot be unlocked with the
PCC, e.g. if the batteries are discharged, then
the left-hand front door can be opened with
the PCC's detachable key blade (see Detach-
able key blade - detaching/attaching (p. 160)).
Hole for key blade - to loosen the cover.
To access the lock cylinder, the door handle's
plastic cover must be removed - this is also
done with the key blade:
1. Press the key blade approx. 1 cm straight
up into the hole on the underside of the
door handle/cover - do not prize.
> The plastic cover loosens automati-
cally by means of the torque when the
blade is pushed straight up and into
the opening.
2. Then insert the key blade in the lock cyl-
inder and unlock the door.
3. Refit the plastic cover after unlocking.
NOTE
When the driver's door is unlocked using
the key blade and is opened, the alarm is
triggered. It is switched off by inserting the
PCC in the ignition switch, see Alarm -
remote control key not working (p. 177).
Related information
•
Keyless drive* (p. 163)
•
Alarm (p. 175)
To Next Page
Loading...
Need help?
General
