Vonyx VXA-3000 User Manual

5
REAR PANEL
1. 6.3mm Jack inputs.
Two 6.3mm jack female input connector for connecting a signal source (mixer etc.).
2. RCA inputs.
Two RCA input connector for connecting a signal source (mixer etc.).
3. Mode Switch.
The amplifier can use 2 different modes: stereo & bridge.
Choose one of these functions:
Stereo mode: Standard left/right stereo mode.
Bridge mode: This mode combines both amps on one channel which results in double power on this channel.
Connects the signal to the left input channel and the output level can now be adjusted with the left volume
control.
4. Ground Lift Switch.
Allows circuit and chassis grounds to be separated in case of problems with earth loops (hum)..
5. 6.3mm Jack Outputs.
Maximum load in stereo mode 4 Ohm per channel.
6. Speaker Outputs NL4.
Maximum load in stereo mode 4 Ohm per channel.
Pin +1 & +2 = + output, Pin -1 & -2 = - output
7. Binding Post Output Jacks.
Maximum load in stereo mode 4 Ohm per channel. Maximum load in bridge mode 8 Ohm.
8. Mains Power Connector
9. Fuse
This main fuse secures the amplifier and wires against defects. Replace this only with a fuse of same type
and value.

Vonyx VXA-3000 Specifications

General

Quantity per pack	- pc(s)
Product color	Black
Purpose	Performance/stage
Frequency band	10 - 20000 GHz
Connectivity technology	Wired
Damping factor	250
Amplifier class	-
Input sensitivity	775 mV
Audio output channels	2.0 channels
Peak power per channel	- W
Signal-to-Noise Ratio (SNR)	90 dB
Total Harmonic Distortion (THD)	- %
RMS power output per channel (4 Ohm)	1500 W
RMS power output per channel (8 Ohm)	1000 W
Bridge-mode power output per channel (8 Ohm)	3000 W
AC input voltage	220 - 240 V
AC input frequency	50 - 60 Hz
Speakers connectivity type	6.35mm

Weight and Dimensions

Depth	482 mm
Width	295 mm
Height	88 mm
Weight	9000 g