30
Programmer’s Cheat Sheet
Wanna remember how you set up your favourite programs? Well this is the place to do it!
Simply do as follows:
1. Indicate where all the knobs are set by drawing a line in the empty circles.
2. Indicate which MODULATION, DELAY & REVERB effects are being used by
colouring in the relevant LED
3. Don't forget to make notes on NR, TAP TEMPO and POWER LEVEL in the
areas indicated!
WORD TO THE WISE: There’s only four panels you can fill out here so do
yourself a favor by photocopying it and then keep a blank “master” so
you can make more copies whenever you like
PROGRAM NAME:
NOTE:
NR (NOISE REDUCTION): POWER LEVELEDIT2[TAP+EDIT 1]:
/TAP
EDIT3[BYPASS+EDIT 1]:
PROGRAM NAME:
NOTE:
NR (NOISE REDUCTION): POWER LEVELEDIT2[TAP+EDIT 1]:
/TAP
EDIT3[BYPASS+EDIT 1]:
To Next Page
Loading...
Need help?
General
