6
Quick start
This Quick Start section is for those of you who would like to start using your new
amp right away.
This manual contains information that will help you take full advantage of your
Valvetronix amp, so be sure to read the rest of it after you’ve read the Quick Start
section.
HINT: Illustrations of the top panel and rear panel are provided in “Top and
rear panels” (p.8), so refer to them as you try out your amp.
Setup
1. Set the VT15/30’s [MASTER] volume to the minimum level.
2. Connect the included power cable to the rear panel AC power connector, and plug
the other end into an AC outlet.
3. Plug the cable connected to your guitar into the top panel INPUT jack.
4. Turn on the [POWER] switch.
5. Slowly raise the [MASTER] volume to adjust the volume.
HINT: The rear panel [POWER LEVEL] control adjusts the output level of
the power amp. This lets you adjust the volume while preserving the dis-
tortion of the power amp.
NOTE: There may be no sound for several seconds until the vacuum tube
warms up. This is not a malfunction.
To Next Page
Loading...
Need help?
General
