29
Remote access
A two-digit security code is required to
access the answering system remotely
from any touch-tone telephone. The
preset code is 19. You can use this
preset code, or set your own.
1. Dial your telephone number from any
touch-tone telephone.
2. When the system plays your
announcement, enter the two-digit
security code.
3. Enter one of the following remote
commands.
Command Description
1 Play all messages.
2 Play only new messages.
3 Delete the current message
(during playback).
33 Delete all old messages.
4 Repeat the current
message (during playback).
5 Stop.
*5 Hear a list of remote
commands.
6 Skip to the next message
(during playback).
*7 Record a new
announcement.
8 End the call.
0 Turn the answering system
on or off.
4. Hang up or press 8 to end the call.
• If you do not press any key after you
enter the remote access code, all new
messages play. If there are no new
messages, all old messages play.
• Once the new messages have played,
the telephone announces the help menu
options. If you do not press any key
within 20 seconds, the remote access call
automatically disconnects.
• When the answering system is turned off,
the telephone answers after 10 rings, and
announces, “Please enter your remote
access code.”
• When the memory is full, the answering
system answers incoming calls after 10
rings and announces, “Memory is full.
Enter your remote access code.”
Set your remote access code
You can set your own remote access
code from 00 to 99.
1. Press MENU when the phone is not
in use.
2. Press q or p to choose Answering
sys and then press SELECT.
3. Press q or p to choose Ans sys
setup and then press SELECT.
4. Press q or p to choose Remote
code and then press SELECT.
5. Press the dialing keys (0-9) to enter
the code, or q or p to select from
00 to 99, then press SELECT to
save. You hear a confirmation tone.
To Next Page
Loading...
Need help?
General
