Managed Services Integration and Planning – VTech CTM-S2412 Cordless SIP Phone - Operation Guide
Phone Usage and Operation– 11
3.9 Call waiting
When you hear a call waiting tone during a call, press FLASH on the cordless handset or the telephone base to put
the current call on hold and take the new incoming call.
Press FLASH at any time to switch back and forth between calls.
3.10 Mute
To mute the microphone:
1.During a call, press MUTE on the cordless handset. The MUTE light turns on when the mute function is turned on.
You can hear the party on the other end but they cannot hear you.
2. Press MUTE again to resume the conversation. The MUTE light turns off.
3.11 Message waiting indicator
When a voice message is received, the MESSAGE WAITING LEDs on the telephone base and handset flash.
3.12 Hold
To place a call on hold on the cordless handset:
1.During a call, press HOLD on the cordless handset. The TALK key on the cordless handset and the LINE key on the
telephone base flash when the call is on hold.
2. Press TALK or /SPEAKER to release the call from hold, or the call will end automatically after the preset call on
hold duration.
To place a call on hold on the telephone base:
1.During a call, press HOLD on the telephone base. The TALK key on the cordless handset and the LINE key on the
telephone base flash when the call is on hold.
2. Press LINE /SPEAKER to release the call from hold, or the call will end automatically after the preset call on hold
duration.
3.13 Find handset
Use this feature to find all registered cordless handsets.
To start paging:
Press /FIND HANDSET on the telephone base when the phone is not in use. All idle cordless handsets beep for 60
seconds.
To end paging:
• Press /FIND HANDSET again on the telephone base.
-OR-
• Press any key on the cordless handset to stop the paging tone.
To Previous Page
Loading...
Need help?
General
