104
Appendix
Expand your telephone system
The handsets provided with your telephone system are already registered.
Additional handsets registered to the telephone system are assigned
in sequential order. For instance, if you already have HANDSET 1 and
HANDSET 2, the new registered handset is assigned HANDSET 3. This
telephone system accommodates up to 12 handsets.
Add and register a handset
You can add new handsets (DS6401, purchased separately) to your
telephone system, but each handset must be registered with the telephone
base before use. When first purchased, each expansion handset shows
Put handset on BASE to register after a battery is installed. You may
need to charge the handset before registering it to the telephone base. For
more details on battery charging, see the table on page 5.
To register a handset:
Make sure the handset is out of the telephone
base or handset charger and shows Put handset
on BASE to register. Place the handset you wish
to register in the telephone base.
The handset displays Registering handset...
and the red IN USE light on the telephone base
turns on. It takes about 90 seconds to complete
the registration process. The handset displays
HANDSET X Registered (X represents the
registered handset number). The IN USE light
on the telephone base turns off and you hear
a confirmation tone from the handset when
registration completes.
If registration fails, the system will automatically try to
register again. If registration fails after the third try, the
handset displays Registration failed then Put handset
on BASE to register and the telephone base beeps.
This may take up to five minutes to occur.
To reset the handset, remove it from the telephone
base. When the handset displays Put handset on
BASE to register, try the registration process again.
1.
2.
You cannot register a handset if any other system
handset is in use.
•
To Next Page
Loading...
Need help?
General
