12
7. Insert the stunt ramp supports in the stunt ramp base slots as shown
below (each stunt ramp support has a notch at its base that fits
the slot it connects to). Then, fit the pegs on the side of the stunt
ramp track into the openings on the stunt ramp supports (pegs on
the side of the stunt ramp track are sized to fit their corresponding
stunt ramp support opening).
8. Insert the small support into the short track with base, then attach
the 60-degree male track to the small support. Next, insert the small
support into the stunt ramp base. You will hear a “click” sound to
indicate the small support is secure.
9. Insert the flag into the video screen piece as shown on the next
page. Then, insert the video screen piece into video screen
SmartPoint
®
straight track as shown on the next page. You will hear
a “click” sound to indicate the video screen piece is secure. Once
the video screen piece is attached to the video screen SmartPoint
®
straight track, it cannot be detached.
Assembly Instructions
To Next Page
Loading...
Need help?
General