www.vtechphones.com
27
Basic Operation
BASIC OPERATION
Batteries
• If you repeatedly
get a low battery
indicator, even
a f t e r c h a r g i n g
o v e r n i g h t , t h e
battery should be
replaced.
• To reduce the risk
of re or injury to
persons or damage
to the telephone,
read and follow
these instructions
carefully: Charge
t h e b a t t e r y
p r o v i d e d w i t h
or identified for
u s e w i t h t h i s
product only in
accordance with
the instructions
and limitation s
specified in the
user’s manual.
Battery Care and Maintenance
After your battery is fully charged, you can expect the following performance:
Operation Operating time
While in use (talking) up to 5 hours
While not in use (standby*) up to 6 days
* Handset is off the base unit or charger but not in use.
• The battery needs charging when:
— A new battery is installed in the handset.
— The phone beeps twice every ve seconds.
— The screen displays BATTERY LOW and the low battery icon.
• Place the handset in the base so the CHARGE light turns on. The battery is typically fully
charged in 16 hours.
• You can keep the battery fully charged by returning the handset to the base after each use.
Replacing the Handset Battery
1. Remove the battery compartment cover on the handset by pressing on the indentation and sliding the
cover downward.
2. Lift out the old battery and disconnect.
3. Align the two holes in the new battery’s plug with the socket
pins, and snap the plug into place. Snap the battery in the
compartment, as described in Installation, on page 5.
4. Replace the cover by sliding it up into place.
5. The new battery must be charged before using the phone.
Place the handset in the base and allow it to charge for at
least 16 hours the rst charge. The telephone might operate
before that, but for best performance, let the battery charge
fully.
To Next Page
Loading...
Need help?
General
