5
5
ASSEMBLY INSTRUCTIONS
With the Drop & Pop Ball Pit
™
, safety comes first. To ensure your child’s
safety, adult assembly is required.
WARNING! This unit contains small screws. For your child’s
safety, do not let your child play with the toy until it is fully
assembled. Adult supervision is recommended.
1. Insert the Electronic Activity Panel to the
Activity Panel Base. Using a screwdriver,
insert the two small screws into the screw
holes on the back of the Activity Panel
Base.
2. Place the Activity Panel Base in the
ball pit. Insert the two blue Attachment
Straps into the slots on the bottom of
the Activity Panel Base, then pull on
the straps until the loops pull through
the slots. Hook the two blue straps on
either side of the Activity Panel Base.
3. Slide the Activity Panel against the
fabric wall. Locate the two slots on the
back of the activity panel and fasten it
to the fabric wall using the Attachment
Clip. You will hear the Attachment Clip
snap into place when inserted correctly.
506200 IM.indd 5 04/19/2017 17:32:06
To Next Page
Loading...
Need help?
General