4
INCLUDED IN THE PACKAGE
• Switch & Go Dinos
®
Rush the Velociraptor
• 2 Discs
• Parent’s Guide
WARNING: All packing materials such as tape, plastic sheets,
packaging locks, removable tags, cable ties, cords
and packaging screws are not part of this toy and
should be discarded for your child’s safety.
NOTE: Please keep this Parent’s Guide as it contains
important information.
GETTING STARTED
BATTERY REMOVAL AND INSTALLATION
1. Make sure the unit is turned Off.
2. Find the battery cover located on
the bottom of the unit and use a
screwdriver to loosen the screw,
then open the battery cover.
3. Remove old batteries by pulling
up on one end of each battery.
4. Install 2 new AA (LR6/AM-3)
batteries following the diagram
inside the battery box. (For best
performance, alkaline batteries or
fully charged Ni-MH rechargeable
batteries are recommended).
5. Replace the battery cover and tighten the screw to secure.
WARNING:
Adult assembly required for battery installation.
Keep batteries out of reach
of children.
To Next Page
Loading...
Need help?
General