ANS.ON/OFF
Security Code & DTAM Operation
SECURITY CODE:
When the handset is put on the cradle, a 16 bits security code will
generate automatically for handset command verification.
NOTE: There is a short
BEEP to indicate that registration has been
successful . When the unit is put in the charge mode, the base will
generate a 16 bit security code to the handset. When the base
receives the acknowledge code from the handset, it means that the
exchange security code is done and the
BEEP is announced.
DIGITAL ANSWER MACHINE OPERATION:
You can operate these DTAM functions when the handset is not in
use.
SETUP: Your VT650 is preset to 'Answer On' and will answer calls
after 2 rings if new messages have been recorded or after 4 rings if
no messages have been recorded.
When set to 'Answer Off', your VT650 will answer calls after 8 rings
if new messages have been recorded or after 10 rings if no new
messages have been recorded.
SWITCHING THE ANSWERING MACHINE ON/OFF:
Press and release
Announces 'Answer Off' or 'Answer On'
18
ANS.ON/OFF
STOP
To Select Outgoing Message (OGM) & New Message Alert
Note: Remember that OGM1 is for normal use and OGM2 is for
'Answer Only' in which the caller cannot leave a message.
TO SELECT OUTGOING MESSAGE:
Press the button and hold to select OGM1 or OGM2
VT650 will play message of your choice.
NEW MESSAGE ALERT:
To set
BEEP alert for new messages
until
BEEP to confirm function is on. The
display will show 'bn'.
press
STOP
until BEEP to confirm function is on. The
display will show 'bf'.
press
To release function
19
To Next Page
Loading...
Need help?
General
