Wacker Neuson BS 60-2i User Manual

wc_tx003049gb.fm
44
Basic Troubleshooting BS 50-2
6 Basic Troubleshooting
Problem Cause Remedy
Engine does not start,
or stalls.
No fuel in tank Add fuel.
Spark plug fouled Clean or replace spark plug.
Engine does not
accelerate, is hard to
start, or runs
erratically.
Improper fuel mix: too much oil Drain fuel and refill with proper
fuel/oil mixture.
Spark plug fouled Clean or replace spark plug.
Obstructed muffler and/or
exhaust port
Clear obstructions.
Leaky crankshaft seals Replace crankshaft seals.
Dirty or clogged air cleaner Service air cleaner.
Engine overheats. Improper fuel mix: not enough
oil
Drain fuel and refill with proper
fuel/oil mixture.
Dirty cooling fins and/or fan
blades
Clean cooling fins and/or fan
blades.
Engine runs, rammer
does not tamp.
Damaged clutch Repair or replace clutch.
Broken connecting rod or
crank gear
Replace broken parts.
Low engine performance:
compression loss
Adjust compression.
Obstructed exhaust port Clear obstructions.
Engine runs, rammer
operation is erratic.
Oil or grease on clutch Remove oil/grease from clutch.
Broken or worn springs Replace broken parts.
Soil buildup on ramming shoe Clean soil from ramming shoe.
Broken parts in ramming
system or crankcase
Replace broken parts.
Engine operating speed too
high
Adjust engine operating speed.

Wacker Neuson BS 60-2i Specifications

General

Brand	Wacker Neuson
Model	BS 60-2i
Category	Power Tool
Language	English