Wacker Neuson BS50-2 User Manual

wc_tx003550gb_FM10.fm
4
Rammer
Foreword
Machine
identification
A nameplate listing the model number, item number, revision number, and serial
number is attached to this machine. The location of the nameplate is shown above.
Serial number
(S/N)
For future reference, record the serial number in the space provided below. You will
need the serial number when requesting parts or service for this machine.
Machine
documentation
■ From this point forward in this documentation, Wacker Neuson Production
Americas LLC will be referred to as Wacker Neuson.
■ Keep a copy of the Operator’s Manual with the machine at all times.
■ Use the separate Parts Book supplied with the machine to order replacement
parts.
■ If you are missing either of these documents, please contact Wacker Neuson to
order a replacement or visit www.wackerneuson.com.
■ When ordering parts or requesting service information, be prepared to provide
the machine model number, item number, revision number, and serial number.
Expectations
for
information in
this manual
■ This manual provides information and procedures to safely operate and
maintain the above Wacker Neuson model(s). For your own safety and to
reduce the risk of injury, carefully read, understand, and observe all instructions
described in this manual.
■ Wacker Neuson expressly reserves the right to make technical modifications,
even without notice, which improve the performance or safety standards of its
machines.
■ The information contained in this manual is based on machines manufactured
up until the time of publication. Wacker Neuson reserves the right to change any
portion of this information without notice.
■ The illustrations, parts, and procedures in this manual refer to Wacker Neuson
factory-installed components. Your machine may vary depending on the
requirements of your specific region.
wc_gr010403
Serial Number:

Wacker Neuson BS50-2 Specifications

General

Engine Model	Wacker Neuson WM 80
Displacement	80 cm³
Percussion Rate	700 blows/min
Fuel Type	Gasoline/oil mixture
Fuel Tank Capacity	3.0 liters
Engine Output	1.8 kW

Summary

Safety Information

Signal Words Used in this Manual

Explains DANGER, WARNING, CAUTION, NOTICE signal words.

Machine Description and Intended Use

Details the rammer's construction, function, and proper use.

Safety Guidelines for Operating the Machine

Covers operator training, qualifications, application area, and safety devices.

Safe Operating Practices

General safety rules for operating the rammer, including PPE.

Personal Protective Equipment for Operation

Lists essential personal protective equipment required for operation.

Service Safety Precautions

Safety precautions for performing maintenance and repairs.

General Servicing Precautions

PPE for Servicing

Safe Service Practices

Operator Safety with Internal Combustion Engines

Hazards and safety guidelines for engines, fueling, and operation.

Lifting and Transporting

Lifting the Rammer

Requirements and procedure for safely lifting the rammer.

Transporting the Rammer

Overview and requirements for transporting the rammer.

Operation

Preparing the Machine for First Use

Steps to prepare the machine before initial operation.

Recommended Fuel and Oil

Details recommended fuel types, oil injection, and oxygenated fuels.

Fuel/Oil Mixing for Non-Oil Injection Models

Refueling the Machine

Filling the Oil Tank

Purging Oil Supply Lines

Purging Oil Discharge Lines

Operator Position and Control

Before Starting Checklist

Starting, Operating, and Stopping the Machine