9 Use and operation
28
9.3 Starting up
Connecting the machine to the electric power supply
The machine may only be connected to AC single phase, connection values see
chapter Technical Data.
1. If required, connect the machine to a permitted extension cable.
Note: See chapter Technical data for the permitted lengths and cross-section
areas of extension cables.
2. Insert the plug into the plug receptacle.
Work tips
When working, use the weight of the hammers.
Pressing forcefully against the material to be worked on does not improve the
machine's performance.
Press the machine against the material to be worked as follows:
Apply at least 100 N pressure.
Press with sufficient strength that the machine noticeably locks into place.
Apply somewhat less pressure as soon as you feel the lower stop.
NOTICE
Electrical voltage.
Incorrect voltage can cause damage on the machine.
f Check if the voltage of the current source corresponds with the information
of the machine, see chapter Technical Data.
WARNING
Electrical voltage.
Injuries from electrocution.
f Check power cable and extension cable for signs of damage.
f Only use extension cables for which grounded conductors are connected to
the plug and the coupling (only for machines of class rating I).
To Next Page
Loading...
Need help?
General
