GP 2500A Maintenance
wc_tx000448gb.fm 31
5 Maintenance
5.1 Maintaining the Emission Control System
Normal maintenance, replacement, or repair of emission control
devices and systems may be performed by any repair establishment
or individual; however, warranty repairs must be performed by a
dealer/service center authorized by Wacker Neuson. The use of
service parts that are not equivalent in performance and durability to
authorized parts may impair the effectiveness of the emission control
system and may have a bearing on the outcome of a warranty claim.
5.2 Periodic Maintenance Schedule
The table below lists basic machine and engine maintenance. Tasks
designated with check marks may be performed by the operator.
Tasks designated with square bullet points require special training
and equipment.
Refer to the engine owner’s manual for additional information.
Daily
before
starting
After
first
20 hrs.
Every
50
hrs.
Every
100
hrs.
Every
300
hrs.
Check the fuel level.
3
Check the engine oil level.
3
Inspect the air filter. Replace as
needed.
3
Check external hardware.
3
Clean the air cleaner element.*
Inspect the shockmounts for damage.
3
Change the engine oil.*
Clean the sediment cup or fuel
strainer.
Check and clean the spark plug.
Check and adjust the valve clearance.
Clean the fuel tank.*
Check condition of the fuel lines.
Replace when necessary.
*Service more frequently in dusty conditions.
To Next Page
Loading...
Need help?
General
