Do you have a question about the Waring MX1000XTXP and is the answer not in the manual?
| Brand | Waring |
|---|---|
| Model | MX1000XTXP |
| Type | Commercial Blender |
| Motor Power | 3.5 HP |
| Capacity | 64 oz |
| Electrical | 120V |
| Speed Settings | Variable |
| Material | Stainless Steel |
| Voltage | 120V |
Read all instructions before using the appliance.
Do not put appliance in water or other liquid to prevent electrical shock.
Always unplug the appliance from the outlet before handling or cleaning.
Appliance not for unsupervised use by persons with reduced capabilities or children.
Unplug appliance when not in use, before attaching/removing parts, or cleaning.
Avoid contact with moving parts during operation.
Do not operate with damaged cord or plug; return for repair.
Use only manufacturer-recommended attachments to avoid hazards.
Do not use the appliance outdoors.
Do not let cord hang over edges or touch hot surfaces.
Keep hands and utensils out of container while blending to prevent injury.
Caution: Blades are sharp; handle carefully.
Always operate the blender with the lid securely in place.
Remove center lid piece when blending hot liquids for venting.
Ear protection is recommended during extended operating periods.
Do not leave the blender unattended while it is running.
Refer to cleaning and sanitizing instructions on pages 6-8.
Appliance uses a 3-conductor cord set for protection.
Appliance uses a 3-prong plug and requires a properly connected grounding-type outlet.
Adapter use for 2-slot outlets requires proper grounding of the outlet cover plate screw.
Ensure outlet cover plate screw is properly grounded before using an adapter.
Adapter use is not permitted in Canada and Europe.
Wire color coding: Green/Yellow for ground, Blue for neutral, Brown for live.
User-installed cord set plugs are not permitted in Europe.
Ensure blender is unplugged, container seated, and plugged into outlet.
Place ingredients in container, cover, and do not fill above MAX line.
Set blender to desired speed between 1 and 10 using variable controls.
Press right paddle switch up to ON; left switch defaults to VARIABLE.
Set paddle switch to Off position when finished blending.
Hold left paddle switch down for pulse; unit runs at max speed.
Allow motor to stop completely before removing container from base.
Hold container with one hand when starting and blending; never operate without lid.
Wash and dry container after each use; refer to cleaning instructions.
Hot materials are defined as those at 100°F (38°C) or hotter.
Limit the amount of hot materials processed to 1 pint.
Remove center lid piece for venting when blending hot materials.
Always start blending hot liquids on the lowest speed setting.
Never stand directly over blender when starting or while it is running.
Clean and dry container after each use to prevent internal seal damage.
Wash, rinse, sanitize, and dry container before first use and after 1-hour intervals.
Wash and rinse container after each use.
Clean and sanitize motor base prior to initial and after each use.
Use non-sudsing detergents and chlorine-based sanitizers (min. 100 PPM chlorine).
Frequent cleaning in batch processing prolongs blade life; max 30 min. run time.
Do not use container to store processed foods or beverages.
Rinse container and lid, add wash solution, scrub, and flush.
Wipe container exterior with damp cloth; wash lid and run solution in container.
Repeat container wash step using clean rinse water.
Wipe container exterior with sanitizing solution.
Fill container with sanitizing solution, run for 1 minute, then dislodge moisture.
Immerse lid and lid insert in sanitizing solution for two minutes.
Do not rinse container, lid, or insert after sanitizing; allow to air dry.
Wipe motor base with dampened cloths; do not immerse in liquids.
Allow motor base to air dry before using.
Refer to enclosed list for nearest Service Center or write to Waring.
Ship blenders for repair to Waring Service Center or Authorized Service Center.
Sterilize items before shipping for service if processing biologically active material.
Replacement parts for out-of-warranty repairs are obtainable at the listed address.
Limited two-year warranty on blender, plus a full three-year warranty on the motor.
Waring will repair or replace defective parts within the warranty period.
Warranty excludes damage from misuse, abuse, unauthorized service, or tampering.
Two-year warranty applies to US/Canada; varies by local importer outside these regions.
Warranty is void if appliance is used on Direct Current (D.C.).