Webasto BlueCool C-Series User Manual

6
A10 Temperature sensor at chilled water circuit defective or absent.
A11 Low pressure cut-out compressor 5 (causes see A01)
A12 High pressure cut-out compressor 5 (causes see A02)
A13 Low pressure cut-out compressor 6 (causes see A01)
A14 High pressure cut-out compressor 6 (causes see A02)
A15 5 seconds after switch-on of chilled water pump, flow monitor detects
insufficient chilled water volume flow
CA11 All compressors have been deactivated. Re-activate with the code menu
INIT Initialization procedure or system block.
bA11 Cabin control panel only.
No error but status information.Indicating that blower is in standby
mode. Blower will automatically start once chilled water circuit has
reached required temperature.

Webasto BlueCool C-Series Specifications

General

Brand	Webasto
Model	BlueCool C-Series
Category	Air Conditioner
Language	English