EasyManuals Logo
Home>Webasto>Water Heater>Thermo Top T

Webasto Thermo Top T User Manual

Webasto Thermo Top T
4 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #2 background imageLoading...
Page #2 background image
Operation
Depending on the type of heater control installed, the heater can be operated by a digital
timer or Telestart.
Prior to switching on the heater, the vehicle's heating system is to be turned to "warm".
In the case of 3-speed blower fans, the vehicle's blower fan is to be set to the lowest
speed, in the case of 4-speed blowers to the second speed. In the case of infinitely
variable fans adjust to at least 1/3 of the fan capacity.
NOTE:
We recommend that the heating time be set in accordance with the driving time.
heating time = driving time
Example: With a driving time of approx. 20 minutes (one way), we recommend
setting an operating time of 20 minutes.
!
n
n
n
be operated with the fuel specified on the namplate.
In the case of a severe build-up of smoke, unusual
combustion noises or fuel smell, the heater is to be put out
of operation by removing the fuse and may only be
restarted after it was inspected by Webasto-trained
personnel.
be operated at least once a month for 10 minutes, with the
vehicle engine cold and at the lowest fan setting. The
heater should be checked annually by a qualified expert,
preferably prior to the heating season commencing.
n Webasto will not assume any liability if the installation
instructions and the notes contained therein are not
observed. The same applies to improperly performed
repairs or those where others than genuine replacement
parts have been used. In those cases, the heater's General
Design Certification and thus the General Operating Permit
(homologation) will be invalidated as a consequence.
The heater :must
Liability claims:
G
Notes:
After an operating period of 30 minutes the fuel supply of the heater will be exhausted.
Allowing the vehicle engine to run for two minutes will replenish the fuel supply.
heaters are equipped with an additional thermostat control resulting in
a higher water outlet temperature during the heating-up phase.
Application: Vehicles with a cubic capacity of more than 1800 cm³.
Thermo Top T
!
If the heater is equipped with the summer/winter switch option, the switch is to be set in
accordance with the respective season. In the "winter" position, the heater will
deliver normal heating output and in the "summer" position only the vehicle's fan for
ventilation of the vehicle's interior will be put into operation.
Setting the Operating Time
Returning to the Default Setting
Checking the Batteries
Press the ON or OFF button.
or
Batteries LED Action
okay after 1 sec.
lights up for
0.5 sec.
in red (heating) or in
green (ventilation)
low charge after 1 sec. flashes
in orange for 3 sec.
- Warm up batteries to above 0°C
- Replace batteries at the next
opportunity
discharged after 1 sec.
lights up for
5 sec. in orange
- Warm up batteries to above 0°C
- Replace batteries
Press the OFF button to call up the next operating time.
To store the setting:
- do not actuate any button for 10 seconds, or
- actuate the ON button.
Press the ON and OFF buttons simultaneously for approx. 10
seconds until the LED extinguishes.
Default setting: heating mode, 30 minutes.

Other manuals for Webasto Thermo Top T

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Webasto Thermo Top T and is the answer not in the manual?

Webasto Thermo Top T Specifications

General IconGeneral
BrandWebasto
ModelThermo Top T
CategoryWater Heater
LanguageEnglish

Related product manuals