EasyManuals Logo
Home>Webasto>Water Heater>Thermo Top T

Webasto Thermo Top T User Manual

Webasto Thermo Top T
4 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #3 background imageLoading...
Page #3 background image
OFF
ON
LED
Telestart T70
General
for Thermo Top
and Thermo Top T optional
with Tele Thermo Top
and Tele Thermo Top T
part of the delivery volume
NOTE:
A minimum distance of 2 m must be maintained between the Telestart
hand-held transmitter and the antenna in the vehicle in the following
cases:
- teaching the codes of the Telestart hand-held transmitter
- switching the heater on and off
- switching the vehicle fan on and off.
Or else, cover the antenna at the hand-held transmitter with your hand
during the transmitting operation.
!
min. 2 m
antenna
The wireless Webasto Telestart T70 enables Webasto heating units
- Thermo Top, Thermo Top T, Thermo Top Z/C and Thermo Top E -
or the vehicle fan to be switched on and off from a distance of up to 600 m.
To switch on the vehicle fan for ventilating the vehicle interior requires a mode change on
the transmitter to be carried out.
The receiver limits the operating time once the heater has been switched on by the
transmitter. The maximum range can be achieved in open country. In built-in areas the
range is likely to be reduced.
Programming Telestart Transmitters
Checking the Mode
Mode setting
Depress the ON and OFF buttons simultaneously twice within
one second.
The newly selected mode (heating or ventilation) will be set in
the receiver the next time a signal is transmitted.
Upon the second actuation, the LED will change its
colour and illuminate until the buttons are released.
Simultaneously depress and hold down the ON and OFF buttons.
LED illuminates:
in : heating mode
in : ventilating mode
LED extinguishes:
- when the buttons are released, or
- after 10 seconds
red
green
2x
1. Place batteries into the battery compartment of the transmitter.
2. Remove fuse 1A (black) from the heater's fuse holder (voltage interruption).
3. Wait at least 5 seconds.
4. Replace fuse in heater's fuse holder and within 5 seconds press the OFF button
on the transmitter for at least 1 second.
5. "Learning" is completed.
A second or third hand-held transmitter can be programmed in the same manner.
min. 1 sec.
OFF
1A 1A
25A
15A
1A
25A
15A
1A
min. 5 sec. max. 5 sec.

Other manuals for Webasto Thermo Top T

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Webasto Thermo Top T and is the answer not in the manual?

Webasto Thermo Top T Specifications

General IconGeneral
BrandWebasto
ModelThermo Top T
CategoryWater Heater
LanguageEnglish

Related product manuals