Webasto Thermo Top T User Manual

Digital Timer with 3 Time Settings
Instant heat Reverse Program selection Forward
Symbol for
setting/
viewing
the time
Program
number
display
Clock button
Heater operation
indicator
Display illumination
1
2
3
SET
Note:
Be sure to take
into account the
switching from
summer time to
winter time (and
vice versa).
!
General
Switching the
heater on
Setting the
time of the day
Viewing
the time
Programming
heater starting
time
Erasing pro-
grammed times
Selecting
preset starting
time
Switching the
heater off
SET
SET
SET
SET
The start of the heating operation can be precisely preset anywhere
between "1 minute" up to "24 hours". Three starts may be
programmed only one of which, however, can be activated.
Manually: by pressing the "instant heating" button
Automatically: by programming the heater starting time
The program number is shown on the display and the display is
illuminated.
Manually: by pressing the "instant heating" button
Automatically: after the programmed operating time has elapsed
The display field is no longer illuminated.
Press the "Clock" button and subsequently "Forward" or
"Reverse" .
Press the "Clock" button
Press the button
Within 10 sec. press the "Forward" or "Reverse" button until the
desired time for the start of the heating operation is shown on the
display.
If a different program number is required, press the button.
Briefly press the button.
Press the button within 10 sec. periods until the program number
associated with the desired preset time is displayed
Hold the hand-held transmitter with the antenna in upright
position and push the ON button for 1 to 2 seconds.
NOTE:
In the 'heating' mode, the vehicle's heating system is to
be set to "warm" prior to leaving the vehicle.
In the 'heating' and 'ventilation' modes, the vehicle's fan
switch is to be turned to position 1 in the case of 3-
speed blower fans, and to position 2 in the case of 4-
speed blowers. In the case of infinitely variable fans
adjust to at least 1/3 of the fan's capacity.
with hand-held transmitter:
with digital timer:
Hold the hand-held transmitter with the antenna in upright
position and press the OFF button for 1 to 2 seconds.
instant heat button to be pressed twice.
!
Switch on heater or ventilation
Switch off heater or ventilation
Checking and Setting the Operating Time
Checking the Operating Time
NOTE:
In the case of Thermo Top and Thermo Top T heaters, an operating time of 20 or
30 minutes has to be set in the 'heating' mode.
Example: The vehicle is used for travelling to work and back.
With a driving time of approx. 20 minutes (one way), we recommend setting an
operating time of 20 minutes.
The operating time of the heater or the vehicle's fan can be preset on the transmitter in
increments of 10 minutes. The operating time is factory-set at 30 minutes.
NOTE:
The first coded flashing signal that is emitted
immediately upon the third actuation of both
buttons has to be included into the count.
The LED flashes in accordance with the preset operating
time.
Simultaneously actuate the ON and OFF buttons within one
second three times in rapid succession.
No. of coded flashing signals
Operating time
1
10 min.
4
40 min.
2
20 min.
5
50 min.
3
30 min.
6
60 min.
3x
!
!

Webasto Thermo Top T Specifications

General

Brand	Webasto
Model	Thermo Top T
Category	Water Heater
Language	English