DRIVE REACH VEHICLE SIGNAL BOOSTER
11
r
ve Reach
M
l N
m
F
ID: PW
4
I
7
A-4
nn
r
MB-
k
ntenna
m
e
ance
hm
requency
698-716 MHz
728-756 MHz
777-787 MHz
824-894 MHz
1850-1995 MHz
1710-1755
2110-2155 MHz
xim
m
w
Power output
or single cell
phone
Uplink
dB
7
MHz
Band 12
17
.
MHz
B
n
1
2
.1
MHz
n
.
17
MHz
n
.
1
MHz
Band 2
2
.
Power output for sin
le cell
phone
Downlink
dB
7
MHz
Band 12
17
5.
MHz
B
n
1
.
MHz
n
5.
21
MH
n
5
1
00 MHz
Band 2
2
5.
Noise Figur
B n
min
l
Isolatio
>
0 dB
Power Re
uirement
V 4.
Each Signal Booster is individually tested and factory set to ensure FCC compliance. The Signal Booster cannot be adjusted without
factory reprogramming or disabling the hardware. The Signal Booster will amplify, but not alter incoming and outgoing signals in order
to increase coverage of authorized frequency bands only. If the Signal Booster is not in use for fi ve minutes, it will reduce gain until a
signal is detected. If a detected signal is too high in a frequency band, or if the Signal Booster detects an oscillation, the Signal Booster
will automatically turn the power o on that band. For a detected oscillation the Signal Booster will automatically resume normal
operation after a minimum of 1 minute. After 5 (fi ve) such automatic restarts, any problematic bands are permanently shut o until the
Signal Booster has been manually restarted by momentarily removing power from the Signal Booster. Noise power, gain, and linearity
are maintained by the Signal Booster’s microprocessor.
This device complies with Part 15 of FCC rules. Operation is subject to two conditions: (1) This device may not cause harmful
interference, and (2) this device must accept any interference received, including interference that may cause undesired operation.
Changes or modifi cations not expressly approved by weBoost could void the authority to operate this equipment.
______
Specifi cations
To Next Page
Loading...
Need help?
General
