CELL PHONE SIGNAL BOOSTER
17
Light O
3. Plug power cable back in to booster.
4. Monitor the indicator lights on your booster. If, after 5 seconds of
‘power on’, a solid or blinking red light appears, repeat steps 1
through 4. Increase the separation distance until the condition is
corrected and/or desired coverage area is achieved. Note: Parallel
separation of the two antennas typically requires a shorter separation
distance than perpendicular separation. If possible, try placing
the antenna directly in front of the location of the booster. A
combination of vertical and horizontal separation distance also
works to prevent oscillation.
5. If you are having any diculties while testing or installing your
booster, contact our weBoost Customer Support team for assistance
(866.294.1660).
If the eqo Signal Booster’s light is o verify power to your surge
protected power strip.
NOTE: The Signal Booster can be reset by disconnecting and
reconnecting the power supply.
NEED HELP?
866.294.1660support.weboost.com
MON - FRI: 6AM to 7PM MST
SAT - SUN: 8AM to 5PM MST
(TROUBLESHOOTING cont.)
After troubleshooting you must initiate a new power cycle by
disconnecting and then reconnecting power to the Booster.
ALWAYS disconnect and reconnect power from the wall adapter, NEVER
from the Booster.
To Next Page
Loading...
Need help?
General
