Weltem WPC-5000 User Manual

8
Owner’s Manual
WPC-3000, WPC-4000, WPC-5000
Maintenance
FILTER CLEANING (See Figures 10 and 11)
There are two fi lters in the unit. The evaporator fi lter is located at the front of the unit. The
condenser fi lter is located at the side of the unit.
1. loosen up 2 bolts on the front fi lter guard.
2. Slide fi lter up and use a vacuum cleaner to remove the dust from the fi lter.
3. If the fi lter is heavily covered with dust and dirt, warm water and mild soap or neutral deter-
gent may be used to wash the fi lter. Do not use any other chemicals to clean fi lter, as they will
likely damage the fi lter.
4. Dry the fi lter in a shaded area before replacing it. Do not operate the unit without the fi lter
installed and the fi lter guard in the closed posi on.
5. Replace the clean fi lter and close the fi lter guard.
6. To clean the condenser fi lter, li up on the side fi lter from the middle bar slightly and then
angle the fi lter outwards from the bo om and remove.
7.Use the same cleaning procedure as above (3 – 5).
8. To replace the condenser fi lter, place the top of the fi lter in the guide and slide the fi lter up
un l the bo om of the fi lter clears the frame. Then push the bo om of fi lter into the guide
and let fi lter gently fall inside the guide.
NOTE: For eff ec ve cooling clean the fi lter at least every 2 weeks.
– For your convenience, record the complete model number and product name (located on the
Product Iden fi ca on Plate), the purchase date, purchase loca on, serial number, and war-
ranty period in the table below.
– Also, a ach your purchase receipt as proof of purchase to this instruc on manual for future
reference.
– To ensure your product is covered by warranty, the complete faulty product along with your
original purchase receipt must be provided at the place of purchase.
Do not operate without the fi lter fi Ʃ ed.
Do not operate the unit with a damaged cord or plug, aŌ er the unit malfunc-
Ɵ ons, or if the unit has been dropped or damaged.
– Loosen up 2 bolts on
the front filter guard.
– Slide filter up and use
a vacuum cleaner to remove
the dust from the filter.
– Remove dust from the filter
using a vacuum cleaner
hose aachment.
– If required wash the filter in
lukewarm water with a mild
detergent. Leave to dry in
a shaded area before
reinstalling.
Figure 10 – Removing Filters
Figure 11 – Removal of Dust

Weltem WPC-5000 Specifications

General

Brand	Weltem
Model	WPC-5000
Category	Air Conditioner
Language	English