SUBSEQUENT STARTING OF THE ENGINE
If this is not the first time using the engine, user should take the following steps to prepare it for
operation.
IMPORTANT: At this point the user should be familiar with the procedures described in the
section titled “Using the Engine for the First Time.” If the user has not yet read this section,
go back and read it now.
Step 1- Check the Oil
Oil consumption is normal during engine usage. The engine is equipped with a low-oil shutoff to
protect it from damage. The oil level in the engine should be checked before each use to ensure
that the engine crankcase contains sufficient lubricant.
To check or add oil, follow these steps:
1. Make sure the engine is on a level surface. Clean around oil fill.
2. Remove the oil filler/dipstick cap and check oil level.
3. If oil level is below the second thread from the lip of the oil fill opening, slowly add oil
until the engine crankcase is filled.
4. Reinstall and tighten oil filler cap before starting the engine. .
Step 2 – Check the Fuel Level
Before starting the engine, check to see that there is sufficient gasoline in the fuel tank. The fuel
gauge on top of the engine will indicate the fuel level in the tank. Add gasoline if necessary but
leave sufficient room in tank for expansion.
WARNING: This engine may emit highly
flammable and explosive gasoline vapors, which can
cause severe burns or even death if ignited. A nearby
open flame can lead to explosion even if not directly in contact with fuel.
• Do not operate near open flame.
• Do not smoke near engine.
• Always operate on a firm, level surface.
• Always turn engine off before refueling. Allow engine to cool for at least 2 minutes
before removing fuel cap. Loosen cap slowly to relieve pressure in tank.
• Do not overfill fuel tank. Gasoline may expand during operation. Do not fill to the
top of the tank. Allow for expansion.
• Always check for spilled fuel before operating. Clean up any spilled fuel before
starting.
• Empty fuel tank before storing or transporting the engine.
• Before transporting, turn fuel valve to off and disconnect spark plug wire.
IMPORTANT:
• Use only UNLEADED gasoline with an octane rating of 87 or higher.
• Do not use old gasoline.
• Never use an oil/gasoline mixture.
• Avoid letting dirt or water into the fuel tank.
9
To Next Page
Loading...
Need help?
General
