Whirlpool AMW 423 - Installation; Prior to Connecting; Mounting the Appliance; After Connecting

7
EN
PRIOR TO CONNECTING
MOUNTING THE APPLIANCE
INSTALLATION
After unpAcking the AppliAnce
, make sure that it has
not been damaged during transport and that the
appliance door closes properly.
in the event of problems
, contact the dealer or the
nearest After-sales Service.
follow The supplieD separaTe mounTing insTrucTions
when installing the appliance.
check ThaT The volTage
on the rating plate
corresponds to the voltage in the home.
Do noT remove
the microwave inlet protection
plates located on the side of the microwave
oven cavity wall. They prevent grease & food
particles from entering the microwave inlet
channels.
ensure The microwave
oven cavity is empty before
mounting.
ensure ThaT The appliance is noT DamageD.
Check
that the microwave oven door closes rmly
against the door support and that the internal
door seal is not damaged. Empty the microwave
oven and clean the interior with a soft, damp
cloth.
Do noT operaTe
this appliance if it has a damaged
mains cord, if it is not working properly, or if it
has been damaged or dropped. Do not immerse
the mains cord in water. Keep the cord away
from hot surfaces. Electrical shock, re or other
hazards may result.
if The power supply
corD
is too short, have a
qualied electrician or serviceman installer an
outlet near the appliance.
The power supply corD
must be long enough for
connecting the appliance, once tting in its
housing, to the main power supply.
for insTallaTion
to comply with current safety
regulations, an omnipolar switch with
minimum contact gap of 3 mm must be utilized.
AFTER CONNECTING
The appliance
can be operated only if the
microwave oven door is rmly closed.
The earThing of This appliance is compulsory.
The
manufacturer will accept no responsibility for
injury to persons, animals or damage to objects
arising from the non-observance of this
requirement.
to prevent Any dAmAge
, only remove the appliance
from its polystyrene foam base at the time of
installation.
children should not perform instAllAtion operAtions
.
Keep children away during installation of the
appliance. Keep the packaging materials (plastic
bags, polystyrene parts, etc.) out of reach of children,
during and after the installation of the appliance.
The manufacTurers
are not liable for any
problems caused by the user’s failure to observe
these instructions.
afTer insTallaTion,
the bottom of the appliance
must no longer be accessible. For correct
appliance operation, do not obstruct the
minimum gap between the worktop and the
upper edge of the oven.